Deck Man Left&Right Handed Thread lag Screws for 1/8″ Decking Cable Railing Kit/Hardware,Non-Turnbuckle System(30 Pairs)


Price: $83.99
(as of Dec 02,2020 09:38:38 UTC – Details)


Product Description

Deck Man Cable RailingDeck Man Cable Railing

We must recognize that in any case we will pursue a concise railing project system,

because it is beautiful、easy to install and maintain;

In addition, it is a simple structure with less problem to happen.

R&L handed thread lag screws for cable railingR&L handed thread lag screws for cable railing

Simple fittings

These R&L handed thread swage lag screws are simplest fittings for your cable railing,really very easy to install.

R&L handed thread lag screws installationR&L handed thread lag screws installation

Simplest fittings for cable railing with wood posts

Note: 1、Please stretch the cable tight before you measure and cut it(hanging heavy objects to tighten the cable is one of the method); 2、Before you connect cable with the screw lags by hydraulic crimper,please make sure the end of cable is inserted into the bottom of lag’s tube; 3、Make sure the hole is perpendicular to the wood post When you install a horizontal railing; 4、Please turn the cable two ends R&L handed screw lags into the screw holes at the same time.

common wrench

common wrench

special wrench

special wrench

Drill correct angle of screw holes

Drill correct angle of screw holes

It is very diffcult to turn the screws by common straight wrench

Common straight wrench will be blocked by nearby cables when turning the lag screws and thickness of common wrench opening doesn’t fit lag screws well,so it will waste a lot of your time.

It is easier to turn the lag screws by this special wrench

The height of the bent wrench can be adjusted freely when turning the lag screw,it won’t be stopped by the nearby cables.(item include this wrench)

Drill screw holes with correct angle

It is very important to drill screw holes with correct angle; Make sure the screw holes are perpendicular to the wood post when you want to install the cable railings horizontally, But if you want to install the stair railings, the screw holes angle should keep the same with the handrail angle.

crimping fittingscrimping fittings

Choosing hydraulic crimper which with #6 dies

Usually 1/8″ fitting only requires 3 times press when it is fixed between the both dies of the hydraulic crimper, the more pressing won’t make the connection stronger but will damage the tool and fittings.

Stainless Steel Grade

T316

T316

T316

304

304

Coated

none

none

none

Indoor and Outdoor

This is Non-Turnbuckle System according to principle of screwing L&R handed thread lag at the same direction and the both lags will go into the opposite direction,So the cable will be tightened by the R&L handed thread lags without torsion force and damage; The length of cable spanning capability of this kit is the same as other common cable railing kits;
This cable railing hardware was made of Marin Grade T316-Stainless Steel, and it can be used indoor and outdoor;
The total length of this lag is 4.1 inch,Length of thread bar is 2 inch,this cable railing lag fit standard 1/8 inch(3.2mm)steel wire rope;and the length of cable is 1 inch shorter than the distance of inner edges of posts which on both sides usually to be recommended;
This Right&Left hand thread screw lags are connected with cable need by using hydraulic crimper(This item not include),and this item go with a correct size dill bit and a special wrench;
When you really understand this non-turnbuckle system,you will find the swage turnbuckles and other trivial parts are not necessary in cable railing system,And this system will be more durable and beautiful.

Back
Open

Close